05 · Auxiliary & Material Handling
Plastic Pipe Shredder Machine
Low-speed twin-shaft shredder for reducing large or thick-wall plastic pipe sections before secondary crushing or controlled recycling.
Selection basis Material · Pipe size · Output · Line speed
Request Component Configuration Role in the Extrusion Line
Mixing, reinforcement and production-waste handling equipment that supports the main extrusion process.
Applications
- Large-diameter pipe sections
- Thick-wall rejected pipe
- Bulky start-up waste
- Pre-shredding before knife crushing
Technical Features
- Low-speed twin-shaft tearing action
- High-torque geared drive
- Feed hopper selected for pipe section size
- Discharge size matched to downstream crushing
Quotation-Based Reference
Quoted Model Range
These are representative Wings Plastic configurations recorded in standard equipment sheets. Final values depend on resin, pipe diameter, wall thickness, output and line speed.
| Quotation status | Engineered to project requirements |
|---|---|
| Primary duty | Large and thick-wall pipe pre-shredding |
| Drive principle | Low-speed, high-torque geared drive |
| Feed opening | Selected by maximum pipe section |
| Discharge target | Matched to the downstream crusher |
| Numerical model data | Not standardized in the supplied quotation sheets |
Model data is provided for equipment selection only. Commercial pricing and customer-specific terms are not published.
Project-Based Selection
Request Configuration Configure this component as part of a complete line
Send the resin, pipe diameter, wall thickness, required output and available factory length. We will match the machine specification to the full process.